Page 1 of 1
Cutting/removing the lining for a better fit of your Speedos
Posted: Thu Jan 29, 2009 3:20 pm
by OZMUSCLE
Hi Guys
I have heard guys are removing or cutting the lining of the Speedos to achieve a better flattering fit.
Do any of you have any recommendations for modifying the lining so that it helps boost/enhance your bulge?
Thanks in advance.
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Sun Feb 01, 2009 2:36 am
by SpeedoMike
just be careful with the scissors or you will need a replacement speedo real quick.

Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Wed Feb 04, 2009 1:19 am
by swimcmk
If you want you stuff to show a lot more cut a small slit in the lining only big enough for you shaft. Then slide you cock and balls through the slit. This will act like a cock ring hold and your stuff forward a lot more
A couple of thing to know
1) Your cock and balls will slide between the layers a lot when you walk, run, swim etc.
2) If you are at the beach or lake sand will get between the layers and it will not come out until you take the Speedo off and rinse it out.
3) The sand will grind into the skin of your cock and balls and irritate the hell out of them.
If you put you cock pointed down:
4) With the lining ,your cock will be forced flat and your balls will be forced a lot lower in the Speedo. If you like the fleeing of a Speedo this may be one of the reasons why.
5) Without the lining you cock might curl around your higher riding balls and it looks like a tennis ball in the front of you Speedo. Is this is a bad thing?
If you point you cock up:
6) Your balls really stand out and you can really see the outline of you cock if you downsize enough to hold them still. Downsize 2 or 3 sizes if you want this effect.
7) The lining and the outer layer really compresses you stuff and hold it still
All in all I like to keep the liner just the way Speedo, Nike, TYR, and Arena and so on made them. I wear Speedos and other Lycra for the compression and the fact that it has controls of my cock and balls and not the show off factor.
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Mon Mar 09, 2009 9:44 pm
by Justin88
swimcmk wrote:If you want you stuff to show a lot more cut a small slit in the lining only big enough for you shaft. Then slide you cock and balls through the slit. This will act like a cock ring hold and your stuff forward a lot more
A couple of thing to know
1) Your cock and balls will slide between the layers a lot when you walk, run, swim etc.
....
If you point you cock up:
6) Your balls really stand out and you can really see the outline of you cock if you downsize enough to hold them still. Downsize 2 or 3 sizes if you want this effect.
....
7) The lining and the outer layer really compresses you stuff and hold it still
Wow. I tried this on an old suit and it really worked. It felt like something from Koala. Took a little work to get my sack through. I wear speedos a lot and usually dont get hard wearing them. But I did in these. Hot feeling your shaft held in one place like that.
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Tue Mar 10, 2009 9:42 am
by Scotty
... but have you worn them in public yet, Justin? lol
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Fri Mar 13, 2009 2:35 pm
by Erik
I don't understand why you would want to cut apart your speedo. Why not just buy a suit that does not have a liner such as an N2N?
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Tue May 12, 2009 4:28 pm
by speedoblob
Hey has anyone else tried any other methods for better fit (or show off :D )
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Wed May 13, 2009 11:24 am
by Scotty
You can always just try a Cock-ring under your Speedo if you dont want to mess with the actual fabric of the suit ...
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Wed May 13, 2009 5:25 pm
by Justin88
Scotty wrote:You can always just try a Cock-ring under your Speedo if you dont want to mess with the actual fabric of the suit ...
Those work. You can turn any suit into a wonderjock. I have the ring that's made out of neoprene that looks like a donut. But it gives me so much bulge I look like ridiculous. a metal one would probly work better.
Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Fri May 15, 2009 2:42 pm
by Scotty
Justin88 wrote:Scotty wrote:You can always just try a Cock-ring under your Speedo if you dont want to mess with the actual fabric of the suit ...
Those work. You can turn any suit into a wonderjock. I have the ring that's made out of neoprene that looks like a donut. But it gives me so much bulge I look like ridiculous. a metal one would probly work better.
lol and I'm sure you mean ri-dick-ulous in a good way

We'd love to see a pic of that

Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Fri May 15, 2009 5:08 pm
by Justin88
Scotty wrote:lol and I'm sure you mean ri-dick-ulous in a good way

We'd love to see a pic of that

Maybe a before and after.

Re: Cutting/removing the lining for a better fit of your Speedos
Posted: Sat May 16, 2009 4:17 pm
by Scotty
Justin88 wrote:Scotty wrote:lol and I'm sure you mean ri-dick-ulous in a good way

We'd love to see a pic of that

Maybe a before and after.

Oh if you're gonna force the issue, sure ... lol

tee-hee